Saturday, December 3, 2011

Building an ACL

 on  with No comments 
In , ,  
The different types of ACLs are first identified by the line number used. Standard IP ACLs use numbers in the range of 1 – 99 and 1300 – 1999. Extended ACLs use numbers in the range 100 - 199 and 2000 – 2699. Other types of ACLs which filter traffic utilizing other protocols such as Appletalk, DECNet, IPX, and XNS use other number ranges, however those are rarely used today. Named ACLs of course do not use numbers, but instead text names as identifiers. Other than ensuring that an ACL number falls into the correct range, the numbers have no meaning and can be used as you see fit.

There are two steps in defining an ACL. First, you enter the series of ACEs that define the ACL. Finally, you apply the ACL to an interface. For a standard ACL, the syntax is as follows:

access-list 10 permit
access-list 10 permit
access-list 20 deny

This simple ACL allows all traffic from hosts with IP addresses in the or network. The “access-list 10” statement signifies that each of these statements belongs to the ACL designated as 10. An extended ACL looks as such:

access-list 100 permit tcp eq www

This extended ACL permits tcp traffic originating from the network with a destination in the network utilizing port 80 (“eq www” means “equals www” or port 80). In addition to ‘eq’ for equals, we can also use “lt” for less than, “gt” for greater than, or “range” to specify a range of ports. To apply an ACL, simply enter the configuration of that interface and specify which ACL as such:

interface Serial0/1
access-group 10 out
line con 0
access-group 15 in

This applies ACL 10 to the Serial0/0 interface, and inspects traffic moving in the outbound direction through that interface. An important thing to note here is that ACLs use wild card masks rather than the more traditional subnet masks used elsewhere when configuring a router. An ACL can be applied to any interface, or to any line (console, aux, or vty).

There are a number of mnemonics used by Cisco IOS to specify ports. You can use the actual port number when configuring the router, however the mnemonic will still be shown in the running configuration and startup configuration. Some mnemonics that you will often see include:
  • bootpc
  • ftp
  • isakmp
  • lpd
  • ntp
  • rip
  • ssh
  • telnet
  • www
or “any” to specify any protocol.

A router can have one ACL per interface, per direction and per protocol. What this means is that each interface may have one ACL in each direction for each protocol that the router supports. For example, in a router that supports IP, IPX and Appletalk, each interface may have an ACL for inbound IP, outbound IP, inbound IPX, outbound IPX, inbound Appletalk, and outbound Appletalk. For a router that supports those three protocols and has 3 interfaces, that router can have 18 active and applied ACLs. An administrator can have as many ACLs defined as memory permits, however only the previously specified 18 may be applied and active.


Post a Comment

Discuss this post!